基于剪切波速的深层砂土地震液化研究     

王薇  李恒  徐利军 《大地测量与地球动力学》2019,39(1):93-97

阐述了剪切波速法判别饱和砂土液化的原理，结合武汉地区某工程实例，对场地内埋深超越“规范法”适用范围的砂层进行液化判别，确定场地的临界液化深度。通过与室内动三轴试验的对比得出，2种方法的液化判别结果及确定的临界液化深度均吻合较好，验证了以剪切波速为指标的液化评估方法的可行性。  相似文献   

井喷关井水击分析及水击波速计算          下载免费PDF全文

史富全 《探矿工程》2020,47(11):37-43

油气井发生溢流或井喷后，立即关闭防喷器，关井期间防喷器需经受关井产生的水击压力作用。本文在对井喷关井水击的传播物理特征分析的基础上，推导直接关井水击压力计算公式，综合考虑井筒流体含气率、气液两相流型、固相类型等对水击波速的影响，推导水击波在气、液、固三相混合流体中传播速度计算公式，并通过算例对水击波速影响因素进行分析。计算表明水击波速对含气率变化非常敏感，钻井液含气率在0～0.001的时候，水击波速几乎是发生了突变，水击波速在含气率为0.001时仅为385 m/s，相比纯钻井液情况下降了67%，而钻井液固相含量、套管的内径和壁厚对水击波传播速度影响较小。  相似文献   

环渤海区域及邻区现今地壳构造运动形变特征分析     

赵旭坤  张俊  雷前坤  范成成 《大地测量与地球动力学》2019,39(11):1101-1105

将环渤海区域划分为5个次级块体，利用整体旋转与线性应变模型分析2009~2014年中国大陆构造环境监测网络的GPS对地观测速度场数据，得到相对于欧亚板块0.5°×0.5°的水平运动速度场和应变场。分析形变速度场和应变场的空间变化发现，环渤海区域整体上呈现0.25×10^-9/a的NW-SE 111.3°的双向趋势性扩张运动，太行块体、山西块体分别呈NW-SE 116.3°、NW-SE 130°的微弱扩张运动，胶辽块体、冀鲁块体和阴山-燕山块体分别存在NW-SE 144.3°、NE-SW 39.5°和NW-SE 155.6°的微弱压缩运动，其中太行块体的扩张运动量级相对于其他次级块体较大。尽管环渤海区域内部各次级块体的形变在空间上存在以上差异，但整体上环渤海区域主压应变轴方向基本为NEE-SWW，主张应变轴方向为NNW-SSE，且主压应变轴走向为NE 47.70°～89.74°，与利用地球物理方法得到的主压应变轴优势方向大体一致，表明环渤海区域现今地壳运动相对稳定。  相似文献   

Investigation into the effect of fault properties on wave transmission          下载免费PDF全文

H.R. Mohammadi  H. Mansouri  M. Bahaaddini  H. Jalalifar 《国际地质力学数值与分析法杂志》2017,41(17):1741-1757

The estimation of wave transmission across the fractured rock masses is of great importance for rock engineers to assess the stability of rock slopes in open pit mines. Presence of fault, as a major discontinuity, in the jointed rock mass can significantly impact on the peak particle velocity and transmission of blast waves, particularly where a fault contains a thick infilling with weak mechanical properties. This paper aims to study the effect of fault properties on transmission of blasting waves using the distinct element method. First, a validation study was carried out on the wave transmission across a single joint and different rock mediums through undertaking a comparative study against analytical models. Then, the transmission of blast wave across a fault with thick infilling in the Golgohar iron mine, Iran, was numerically studied, and the results were compared with the field measurements. The blast wave was numerically simulated using a hybrid finite element and finite difference code which then the outcome was used as the input for the distinct element method analysis. The measured uplift of hanging wall, as a result of wave transmission across the fault, in the numerical model agrees well with the recorded field measurement. Finally, the validated numerical model was used to study the effect of fault properties on wave transmission. It was found that the fault inclination angle is the most effective parameter on the peak particle velocity and uplift. Copyright © 2017 John Wiley & Sons, Ltd.  相似文献   

Stress‐dependent elastic wave velocity of microfractured sandstone     

Daisuke Katsuki  Marte Gutierrez  Abdulhadi Almrabat 《国际地质力学数值与分析法杂志》2014,38(5):441-456

A model for the stress‐dependent elastic wave velocity response of fractured rock mass is proposed based on experimental evidence of stress‐dependent fracture normal and shear stiffness. Previously proposed models and previous experimental studies on stress‐dependent fracture stiffness have been reviewed to provide a basis for the new model. Most of the existing stress‐dependent elastic wave velocity models are empirical, with model parameters that do not have clear physical meanings. To propose the new model, the rock mass is assumed to have randomly oriented microscopic fractures. In addition, the characteristic length of microfractures is assumed to be sufficiently short compared to the rock mass dimensions. The macroscopic stress‐dependent elastic wave velocity response is assumed to be attributed to the stress dependency of fracture stiffness. The stress‐dependent fracture normal stiffness is defined as a generalized power law function of effective normal stress, which is a modification of the Goodman's model. On the other hand, the stress dependency of fracture shear stiffness is modeled as a linear function of normal stress based on experimental data. Ultrasonic wave velocity responses of a dry core sample of Berea sandstone were tested at effective stresses ranging from 2 to 55 MPa. Visual observation of thin sections obtained from the Berea sandstone confirms that the assumptions made for microstructure of rock mass model are appropriate. It is shown that the model can describe the stress‐dependent ultrasonic wave velocity responses of dry Berea sandstone with a set of reasonable material parameter values. Published 2013. This article is a U.S. Government work and is in the public domain in the USA.  相似文献   

Radial velocity studies of HeII and Hβ emission from cataclysmic variables     

《New Astronomy》2014

  相似文献   

GPS在机载雷达测速精度鉴定中的应用     

王云河  王存良 《全球定位系统》2010,35(2):5-8

论述了利用GPS来鉴定机载雷达的测速精度，推导了雷达对目标径向的速度基准值计算公式及其精度计算公式，并计算了该速度基准值及其精度，结果表明：能够满足速度基准值精度要求。强调了在做测速精度鉴定方案时，需要计算在被鉴定速度方向上的速度基准值精度是否满足要求。  相似文献   

提高河口地区水下地形测量精度的方法     

许宝华  何慧兰 《地理空间信息》2010,8(5):126-127,143

采用配备多元传感器的高精度的无验潮水下地形测量模式、根据测区温度和盐度变化采用声速仪对声速进行实时改正、对系统时延进行准确的改正、正确的测量数据处理等来提高河口地区水下地形测量精度。  相似文献   

Analysis of Manning coefficient for small‐depth flows on vegetated beds     

R. García Díaz 《水文研究》2005,19(16):3221-3233

The limitations of Manning's formula are analysed when it is in extreme conditions, and more specifically with small‐depth flows on natural‐vegetation beds. A thorough analysis is made of research carried out on macro‐rough beds, placing particular emphasis on vegetated beds. Research carried out to date on the roughness of vegetated beds and macro‐roughness is commented on, including that carried out at the Laboratory of Hydraulics and Hydrology of the Forestry Engineering Faculty (Polytechnic University of Madrid). The work was done in two phases, the first in a laboratory channel with artificial vegetation and the second in natural beds. The results of the experimental research allow the development of a new approximate method of determining Manning coefficient according to the Froude number. This method may be applied in extreme conditions, both in small depths and steep slopes. It was proved that the Manning coefficient depends not only on roughness height, but also on depth and slope values; thus, it is advisable to choose the appropriate method for its calculation. Copyright © 2005 John Wiley & Sons, Ltd.  相似文献   

Modelling combined open channel flow by artificial neural networks     

Han‐Chung Yang  Fi‐John Chang 《水文研究》2005,19(18):3747-3762

Combined open channel flow is encountered in many hydraulic engineering structures and processes, such as irrigation ditches and wastewater treatment facilities. Extensive experimental studies have conducted to investigate combined flow characteristics. Nevertheless, there is no simple relationship that can fully describe the velocity profiles in a turbulent flow. The artificial neural network (ANN) has great computational capability for solving various complex problems, such as function approximation. The main objective of this study is to evaluate the applicability of the ANN for simulating velocity profiles, velocity contours and estimating the discharges accordingly. The velocity profiles measured by an acoustic doppler velocimeter in the open channel of the Chihtan purification plant, Taipei, with different discharges at fixed measuring section and different depths are presented. The total number of data sets is 640 and the data sets are split into two subsets, i.e. training and validation sets. The backpropagation algorithm is used to construct the neural network. The results demonstrate that the velocity profiles can be modelled by the ANN, and the ANN constructed can nicely fit the velocity profiles and can precisely predict the discharges for the conditions investigated. Copyright © 2005 John Wiley & Sons, Ltd.  相似文献